Hydrophore sequence relay

General Information

Hydrophore changeover relays have been designed to

be started when necessary and run simultaneously.

Device Use and Operating Principle

The sequence of hydrophores is as follows: (H1) - (H2) - (H3) and (H1-H2) -.

(H2-H3) - (H1-H3). It activates the hydrophores in the same number

where the switches are closed and keeps them running for "t" time. At the end of "t" time, the next hydrophore or group of hydrophores will be activated and

it continues in this manner. It deactivates the hydrophores in the same number

where the switches are open.

Note: Do not connect power to the inputs and outputs (P1, P2, P3)

of the pressure switch.

Maintenance

Turn off the device and unplug it from the connectors. Clean the cone of the device with a swab. Do not use wires or chemicals that may

damage the device. After cleaning, ensure that the device works.

Warning

Use the device according to the instructions for use.

Do not use the device in a humid environment.

The assembly includes a switch and a circuit breaker.

Place the switch and circuit breaker near the equipment so that the operator can easily reach them.

Mark the switch and circuit breaker as

release connector for the equipment.

Technical Specifications:

Operating Voltage (Un).....: 150-250V AC

Operating Frequency.......: 50/60 Hz.

Operating Power..............: <6VA

Operating Temperature....: -20°C.... +55°C

Time(t)......................: 10 minutes

Display......................: HSR-02=5 x LED, HSR-03=7 x LED

Connection Type............: Clamp connection

Contact.....................: 3A/250V AC (resistive load)

Number of Hydrophores........: 2(HSR-02) and 3(HSR-03)

Cable Diameter..............: 1.5mm²(HSR-02), 2.5mm²(HSR-03)

Weight..........................: Max. 220g.

Mounting..........................: Vertical panel mounting or DIN rail mounting.